Advertisement
Advertisement
Table of Contents
Related Manuals for Ryobi R18NL
Summary of Contents for Ryobi R18NL
- Page 1 ORIGINAL INSTRUCTIONS 18V EP Nailer R18NL...
- Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
- Page 3 Fig. 1...
- Page 4 Fig. 2 Fig. 3 Fig. 4 Fig. 5...
- Page 5 Fig. 6 Fig. 7 Fig. 8...
- Page 6 Fig. Fig. 9 Fig. 11 Fig. 12...
-
Page 7: General Power Tool Safety Warnings
tool. Do not use a power tool while you are GENERAL POWER TOOL SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious WARNING personal injury. Read all safety warnings and all instructions. -
Page 8: Nailer Safety Warnings
or binding of moving parts, breakage of parts ■ Always assume that the tool contains nails. and any other condition that may affect the Careless handling of the nailer can result in unexpected power tool’s operation. If damaged, have the firing of nails and personal injury. - Page 9 Z89.1-1997 is used. OPERATION ■ Keep fingers away from trigger when not driving ■ Do not use tool if trigger does not actuate properly. fasteners to avoid accidental firing. Any tool that cannot be controlled with the trigger is dangerous and must be repaired. ■...
-
Page 10: Intended Use
not place second hand on top of tool or near exhaust ■ Furniture at any time. Failure to heed this warning can result in NOTE: Some timbers (such as very dry hardwood) may serious personal injury. require shorter nails to fully drive in. ■... - Page 11 Dry-fire lockout WARNING The dry-fire lockout feature keeps the tool from operating To prevent accidental starting that could cause serious when nails are low in the magazine to prevent missing nails personal injury, always remove the battery pack from the in the nail pattern and extend tool life.
- Page 12 Remove the battery. Remove the pad by pulling it down ■ Turn the depth of drive adjustment left or right to change and away from the nose. To replace the pad, fit it into place the driving depth. over the nose and push up to reseat. ■...
-
Page 13: Environmental Protection
■ Remove battery pack from the tool. BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING ■ To remove a strip of nails from the tool, depress the magazine release button located at the rear of the WARNING magazine and slide the magazine open. Upon removal, cover the battery pack’s terminals with ■... -
Page 14: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Work-contacting element does not depress Nails are low. Replenish the nails. fully - tool does not operate. Work-contacting element is jammed. Remove the battery and clear the debris. Tool operates properly, but fasteners are Air pressure is too low. Increase the air pressure. -
Page 15: Product Specifications
PRODUCT SPECIFICATIONS BATTERY AND CHARGER Voltage 18 V Compatible battery Compatible charger pack (not included) (not included) Magazine capacity 105 nails Lithium-Ion BPL-1820 BCL1418 Nail type 18 gauge BPL-1815 BCS618 BPL18202PK BCL14181H Brad nail length 15 - 50 mm RB18L13 BCL14183H (5/8 - 2”) RB18L15... - Page 16 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 961152167-01...