Advertisement
Advertisement
Table of Contents
Related Manuals for Ryobi R18NL15
Summary of Contents for Ryobi R18NL15
- Page 1 ORIGINAL INSTRUCTIONS 18V Nailer (15Ga) R18NL15...
- Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
-
Page 3: Intended Use
Safety WORK AREA SAFETY INTENDED USE ■ Keep work area clean and well lit. Cluttered or Safety, performance, and dependability have been given dark areas invite accidents. top priority in the design of your nailer. ■ Do not operate power tools in explosive The product is intended to drive nails in soft materials such atmospheres, such as in the presence of as wood. -
Page 4: Nailer Safety Warnings
Safety have the switch on invites accidents. BATTERY TOOL USE AND CARE ■ ■ Remove any adjusting key or wrench before Recharge only with the charger specified by the turning the power tool on. A wrench or a key left manufacturer. - Page 5 Safety ■ The mechanism may be under compression and the Only fasteners matching the description in the product fastener may be forcefully discharged while attempting specification table can be used with this tool. Using to free a jammed condition. incorrect fasteners may lead to jamming or other malfunctions.
- Page 6 Safety Dust mask, nonskid safety shoes, hard hat, or hearing as accidental driving of a nail may result. Do not protection must be used for appropriate conditions. interfere with the proper operation of the workpiece contact mechanism. ■ Protect your lungs. Wear a face or dust mask if the ■...
-
Page 7: Environmental Protection
Safety Do not use lubricants on nails, nail magazine or driving WARNING mechanism. Keep clean. Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. -
Page 8: Know Your Product
Know your product 1. No-mar pad 9. Pusher 2. Workpiece contact 10. Depth of drive adjustment 3. Jam release latch 11. Rear loading magazine 4. LED worklight 12. No-mar pad replacement 5. Air pressure lever 13. Belt clip screw 6. Switch trigger 14. -
Page 9: Getting Started
Getting started... - Page 10 Getting started...
-
Page 13: Operation
Operation... -
Page 14: Maintenance
Maintenance... - Page 15 Maintenance...
- Page 16 Maintenance...
-
Page 17: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Work-contacting element does not depress Nails are low. Replenish the nails. fully - tool does not operate. Work-contacting element is jammed. Remove the battery and clear the debris. Tool operates properly, but fasteners are Air pressure is too low. Increase the air pressure. - Page 18 Techtronic Industries (Australia) Pty. Ltd. 31 Gilby Road, Mount Waverley VIC 3149, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 961152489-01...