Maintenance And Care; Power Cord - Bissell 58F8 User Manual

O
peration

Power cord

the power cord is located on the right of
the vacuum. Gently pull out the power cord,
watching for the yellow line. Stop pulling the
power cord once the yellow line is visible.
there is also a red line, which indicates the
end of the usable cord. Do not pull the power
cord out beyond the red line.
Automatic cord rewind
your vacuum is equipped with an automatic
cord rewind. When cleaning is finished, press
the power button oFF and grasp the plug to
disconnect from the electrical outlet. hold the
plug and press the automatic cord rewind
button to rewind the cord automatically.
M
aintenance and care
to maintain maximum cleaning performance, the
following maintenance steps must be performed:
1.
Empty the dirt container when the dirt
reaches the "Full" line on the side.
2. Check the inner and outer circular filters and
the pre-motor filter at least once a month
and clean or replace as needed.
3.
Check and replace the HEPA media
post-motor filter as needed.
note: More frequent filter cleaning or
replacing may be necessary if you are
vacuuming new carpet, fine dust, or have
allergy concerns. Follow the instructions on
the following pages to perform these simple
maintenance steps.
Empty Dirt Container
the dirt container needs to be emptied when
the dirt reaches the "Full" line on the side of the
container.
1. Turn power off. Unplug cleaner from
electrical outlet.
2.
Slide the Lock 'n Seal lever to the "Unlock"
position.
8
w w w . b i s s e l l . c o m
caUtIon:
be careful to avoid
injury as cord retracts
very quickly.
WaRnInG:
to reduce the risk of
electric shock, turn
power switch oFF and
disconnect polarized
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
Tip:
For maximum cleaning
performance, check
and clean or replace all
filters as suggested.
2.
Unlock Position
Full Line
Lock Position
8 0 0 . 2 3 7 . 7 6 9 1