Table of Contents
Advertisement
VGS-1 OPTIONAL VOICE GUIDE & STORAGE UNIT
V
R
OICE
ECORDER
The voice recorder allows you to record conversations and
create voice memos.
■ Auto Recording (NX-200/ NX-300/ NX-200G/ NX-300G Only)
If activated, the auto recorder will continuously record all
transmitted and received signals. The recording storage
area retains only the last 30 seconds of recording.
■ Voice Memos (NX-200/ NX-300/ NX-200G/ NX-300G Only)
To record a voice memo for later playback:
1 Press the key programmed as Voice Memo, press and
hold the key programmed as Playback, or access the
Menu {page 15}.
•
The duration of recording memory will appear on the
display and begin counting down.
2 Speak into the microphone to record your memo.
3 Press
•
If the memory becomes full, recording will stop and the
voice memo will be stored in memory.
■ Auto Reply Message
(NX-200/ NX-300/ NX-200G/ NX-300G Only)
You can set the transceiver to automatically respond to
Individual Calls while using FleetSync/NXDN.
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
2 When you receive an Individual Call, the transceiver will
send an automatic response to the caller after
3 seconds, and "GREETING" appears on the display.
•
If you are available to receive the call, press any key to
cancel the auto response.
•
If there is memory available on your transceiver, "I am not
available. Leave your Message." will be sent to the caller
32
to end the recording and store it in memory.
Advertisement
Table of Contents
