Product Maintenance; Troubleshooting - Fellowes BB62811 Manual

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug Locate Auto-start
shredder infrared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36054.
Remove Paper: When illuminated, press reverse (
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (125Ci only).
4
.
3
Dip cotton swab in
rubbing alcohol
AUTO
4
Using cotton swab, wipe
away any contamination
from the paper sensors
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
ENGLISH
Models 125Ci/125i
®