Product Maintenance; Troubleshooting - Fellowes BB64231 Manual

ADVANCED PRODUCT FEATURES ADVANCED PRODUCT FEATURES
Jam Blocker
they start
JAM BLOCKER
1 2
If Remove Paper icon ( ) is
illuminated, there is too much paper an acceptable amount and
for the shredder to power through
refeed into paper entry
SET-UP AND TESTING SET-UP AND TESTING
1 2
Set to Auto-On ( )
Touch test area and
look for the SafeSense
indicator to illuminate

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off ( ) *Apply oil across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open/Bin Full: The shredder will not run if the bin is open or full. When illuminated, close or empty the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On (
TM
TM
1
Shredder pauses for
3 seconds
SAFESENSE TECHNOLOGY
®
Stops shredding immediately when hands touch
the paper opening.
3 4
SafeSense is active and If hand is held on SafeSense
®
working properly area more than 3 seconds
®
shredder will shut off
3
Press and hold Reverse
( ) 2-3 seconds
SafeSense ® Technology
Stops shredding immediately when
hands touch the paper opening
If Remove Paper icon illuminates during the shredding process
(due to paper misfeed or wrinkle) follow the procedures below.
2
Set to Reverse ( )
and remove paper
standby mode and sleep mode.
WHEN IN SLEEP MODE
1
®
In sleep mode
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Turn off ( ) and Locate Auto-start
unplug shredder infrared sensor
® indicator will illuminate and the shredder will stop shredding. If SafeSense
Energy Savings System
Optimal energy efficiency 100% of
the time – in use and out of use
3
Set to Auto On ( Set to Auto On ( ) and ) and
refeed into paper entry refeed into paper entry
ENERGY SAVINGS SYSTEM
Optimal energy efficiency 100% of the time –
in use and out of use.
2 3
or
To get out of sleep mode set to
Insert paper
OFF ( ), then Auto On ( )
.
3 4
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
®
) to resume shredding.
3