Handset Installation; Installing The Charger - VTech ErisTerminal VSP600A User Manual

Handset Installation

This section assumes that your network infrastructure is established and that
your IP PBX phone service has been ordered and configured for your location.
Handset installation involves both the handset and the handset charger. The
charger is powered using the supplied power adapter. The charger can be placed
on a flat surface or mounted on a wall.
Avoid placing the handset and charger too close to:
• Communication devices such as television sets, DVD players, or other
cordless telephones
• Excessive heat sources
• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting
• Excessive dust sources such as a workshop or garage
• Excessive moisture
• Extremely low temperature
• Mechanical vibration or shock such as on top of a washing machine or work
bench

Installing the charger

Install the charger as shown below.
Plug the power adapter into an electrical outlet not controlled by a wall switch.
To electrical outlet
16