Important safety instructions When using your appliance, basic precautions should always be followed, including the following: • Read all instructions before using this product. • This product has been designed for indoor, domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
Page 3
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Page 4
fire, electrical shock or injury to persons when the appliance is used. • Close supervision is necessary for any appliance being used by or near children. • Do not leave the appliance unattended while plugged in or while it is still hot. •...
Page 5
and may result in fire, electric shock or personal injury. • The appliance must be rested on a stable, heat and waterproof surface. When placing the appliance on its base, ensure that the surface on which the base is placed is stable. •...
PRODUCT DESCRIPTION On/Off light indicator Cord exit 2. EN 8. EN On/Off button Standing base 9.* EN Steam head Door hook 4. EN 10.* EN Steam button Steam cover 11.* EN Water tank locker Fabric brush 6. EN Removable water tank Depending on model...
BEFORE USE When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small discharge of particles. This will not affect the use of the appliance and will disappear quickly. Press the water tank locker. Remove the water tank.
Page 9
Close the water inlet stopper. Return the water tank to its place for locking on the appliance. Make sure that the water tank is fully set in place. As steam is very hot: never attempt to remove creases from a garment while it is being worn, always hang garments on a clothes hanger.
Page 10
ACCESSORIES The door hook allows you to hang your garment for steaming. The fabric brush opens the weaves of the fabrics for better steam penetration. Before removing or attaching the steam brush, unplug your appliance and allow it to cool down, for one hour.
Page 11
Plug-in the appliance. Switch on the appliance. Wait until the light stops flashing (approximately 45 seconds). When the light is steady the appliance is ready to use. Press the steam button with the steam brush facing away from you holding it in a vertical position.
Page 12
Tips: Check the fabric’s label for recommendations. We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to ensure these fabrics are not damaged by hot steam. For optimal use, pass the steam jets over your garment from top to bottom.
AFTER USE Press the On/Off button to switch the appliance off. Unplug the appliance. Wait for an hour for your appliance to cool before storing.
Page 14
Press the water tank locker. Remove the water tank. Empty the water tank completely. Return the water tank to its place on the appliance, lock it.
Page 15
ANTI CALC Do this operation in a vented room. Press the water tank locker. Remove the water tank. Water Water Fill the water tank with 50% water and 50% white vinegar. Do not use other descaling products. White White Vinegar Vinegar...
Page 16
Return the water tank to its place on the appliance. Make sure the water tank is fully set in place and locked. Plug-in the appliance. Switch on the appliance. Wait until the light stops flashing (approximately 45 seconds). When the light is steady the appliance is ready to use.
Page 17
To release steam, press continuously on the steam button. Allow the appliance to run until the water tank has completely emptied. Press the On/Off button to switch the appliance off. Unplug the appliance and press the water tank locker. Remove the water tank.
Page 18
150 ml Fill the water tank with a maximum of 150 ml of untreated tap water. Return the water tank to its place on the appliance. Make sure the water tank is fully set in place and clicked. Plug in the appliance. Switch on the appliance.
Page 19
Wait until the light stops flashing (approximately 45 seconds). When the light is steady the appliance is ready. To release steam, press continuously on the steam button. Allow the appliance to run until the water tank has completely emptied.
Page 20
CLEANING Wait an hour for the appliance to completely cool down. Clean the plastic parts of the appliance with a damp cloth. Never wash or rinse appliance directly over a sink.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS There is no steam. The appliance is not plugged in, or Check that your appliance is correctly not switched on. plugged in and switched on. The water level is too low. Unplug your appliance and refill it. The steam pump has not been Press the steam trigger continuously primed.