Tools Needed; Opener Contents - Chamberlain Power Drive Assembly & Installation Manual

2 X 4 Board
Tape Measure
Pencil
Your garage door opener is packaged in one carton which contains the motor unit and the parts illustrated below. Note
that accessories will depend on the model purchased. If anything is missing, carefully check the packing material. Parts
may be stuck in the foam. Hardware for assembly and installation is shown on the next page. Save the carton and
packing material until installation and adjustment is complete.
A5
Hanging Brackets
Straight Door
Arm Section
A1
Chain and Cable in
Curved Door
Dispensing Carton
Arm Section
A4
Motor Unit with Light Lenses
(varies depending
upon model purchased)
A21
A18
Assembly and
Installation Hardware
Door Control Button
Model 248730 ONLY
Adjustable End Wrench
Stepladder

OPENER CONTENTS

A9
Garage Door Monitor
(Model 7920KD only)
A2
A3
Chain Spreader
with Screws
Safety Sensor
Bracket (2)

TOOLS NEEDED

1/4" Nutdriver
Wire Cutters
Pliers
Phillips and Flat Screwdriver
Claw Hammer
A20
A7
A6
Rail
Door
Center/Back
Control
Sections (4)
All Other
Models
A12
Idler Pulley
(included with hardware)
Safety Labels
and Literature
Models
PD210D (1)
PD212D (2)
248730 (1)
A10
A15
Door Bracket
4
Drill Bits
3/16", 5/16"
and 5/32"
Sockets and Wrench
1/2", 5/8", 7/16", 9/16"
and 1/4"
Hack Saw
A8
Rail
Front (header)
Section (1)
A13
Trolley
A16
Remote Control Transmitter
The Protector System
(2) Safety Reversing Sensors
(1 Sending Eye and 1 Receiving Eye)
with 2-Conductor White and White/Black
Bell Wire attached
Drill
Carpenter's
Level (Optional)
A11
"U" Bracket
A19
Keyless Entry
Models
PD612KLD (1)
7920KD (1)
A14
Header Bracket
Models
PD610D (1)
PD612D (2)
PD612KLD (2)
48930D (2)
7920KD (2)
A17
®