Lighting Instructions - Napoleon BILEX4851 Manual

Lighting Instructions

Lights
Left
Burner
WARNING!
Open lid.
WARNING!
Ensure all burner controls are in the off position. Turn on the gas supply
valve.
Main Burner
Lighting
1. Open grill lid.
2. Push and turn any main burner knob slowly
to the 'hi' position. This action will ignite the
pilot flame which will in turn light the selected
burner. If the pilot lights, continue to push
down on the control knob until the burner
lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob back to the
'off position and repeat step 2 several times.
4. If the pilot and burner will not ignite within
5 seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess gas
to dissipate. Either repeat steps 2 and 3 or
light with a match.
5. If lighting the unit with a match, clip the
match into the supplied lighting rod. Hold the
lit match down through the grill and sear plate
while turning the corresponding burner valve
to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.
Left Centre Right
Right Centre
Burner Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame which
will in turn light the burner. If the pilot
lights, continue to push down on the burner
control knob until the burner lights then
release.
4. If the burner does not ignite, then imme-
diately turn the control knob back to the 'off'
position and repeat step 3 several times.
5. If the burner will not ignite within 5
seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess
gas to dissipate. Either repeat steps 3 and 4
or light with a match.
Lighting Hole
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner control to
high position.
3. Press and hold igniter button until
burner lights, or light by match.
4. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.
www.napoleongrills.com
7
EN