Supero SUPERSERVER 1026TT-TF User Manual page 49

Overheat/Fan Fail/PWR Fail/UID
LED
Pins 7 and 8 of JF1 are for the Over-
heat/Fan Fail/Power Fail and UID LED
connections. The red LED (pin 8) pro-
vides warnings of overheat, fan failure
or power failure. The blue LED (pin 7)
is for the UID LED indicator for the
control panel UID button. Refer to the
tables on the right for pin defi nitions.
NIC2 (LAN2) LED
The LED connections for LAN2 are
on pins 9 and 10 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.
NIC1 (LAN1) LED
The LED connections for LAN1 are
on pins 11 and 12 of JF1. Attach LAN
LED cables to display network activ-
ity. See the table on the right for pin
defi nitions.
HDD LED
The HDD LED and UID switch con-
nections are located on pins 13 and
14 of JF1. Attach a hard drive LED
cable here to display disk activity. This
connection is also used for the front
panel UID switch. The UID LED on
pin 7 of JF1 works in conjunction with
this switch. See the table on the right
for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
OH/Fan Fail/ PWR Fail/Blue_UID
LEDPin Defi nitions (JF1)
Pin# Defi nition
7 Blue UID LED/5.5V.SB
8 OH/Fan Fail/PWR Fail/Red UID
LED
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State
Off
On
Flashing
Pin Defi nitions (JF1)
Pin#
9
10
Pin Defi nitions (JF1)
Pin#
11
12
Pin Defi nitions (JF1)
Pin#
13
14
5-15
Defi nition
Normal
Overheat
Fan Fail
NIC2 LED
Defi nition
Vcc
Ground
NIC1 LED
Defi nition
Vcc
Ground
HDD LED
Defi nition
UID Signal/3.3V
HDD Active