Advertisement
Available languages
Available languages
INSTALLATION
Installation
Ensure the sides of the cabinetry opening are adequate
1
to support installation of the slides. If necessary, install
additional side cleats maintaining the opening width.
Position slides on the sides of the cabinet opening as
2
shown in the illustration below. Spacer material provided,
can be added under or at the sides of the cabinet to
ensure a proper fit. If the unit is to be installed over a
warming drawer, use the top surface as a reference
to position slides (there will be no surface to rest the
slides on).
Secure the slides with screws provided. Extend slides
3
forward to full extension.
356
mm
254
mm
19 mm
TYPICAL
Slide support.
Install slides.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design, are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Position the unit on the slides. Verify the pins are inserted
4
into the housings properly, then secure with screws pro-
vided. If the height of the unit requires adjustment, use
the spacer disks provided. Refer to the illustration below.
Secure the power cord clip provided to the top of the
5
cabinet opening, centered and approximately 356 mm
back from the front edge. Position the power cord
through it and plug into the electrical outlet on the
back wall of the opening. The power cord must be long
enough to allow the unit to be slid forward.
POWER
CORD CLIP
C L
SPACER DISK
Install unit on slides.
Install power cord clip.
COMPLETE THE INSTALLATION
Fill the water tank.
1
Slide unit forward and press the main power switch
2
located behind the front (right) control panel.
Select desired language. To select, scroll through
3
languages until desired language is displayed, then press
and hold
.
Press
. Hot water will be dispensed from the hot
4
water spout.
The unit will turn off automatically after initial power up is
5
complete.
Troubleshooting
IMPORTANT NOTE:
If the coffee system does not operate
properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the unit.
•
Verify proper electrical connections.
•
If the coffee system does not operate properly, con-
tact Wolf factory certified service. Do not attempt to
repair the appliance. Wolf is not responsible for service
required to correct a faulty installation.
wolfappliance.com
|
5
Advertisement
