Desa CGEFP33NRC Owner's Operation And Installation Manual page 19

Table of Contents

Advertisement

INSTALLATION
Continued
4. Place left crossover log (#4) across logs #1,
#2 and #3 fitting holes on bottom of log #4
onto pin on front and middle logs as shown
in Figure 32.
5. Place right crossover log (#5) in the
same manner on right side of logs (see
Figure 32).
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Crossover
Log (#4)
Pins
Figure 32 - Installing Crossover Logs
(#4 & #5) (Base may vary from illustration)
INSTALLING BATTERIES IN
REMOTE CONTROL AND RECEIvER
WARNING: Make sure your
selector switch is in OFF posi-
tion before installing or chang-
ing batteries in your hand-held
remote or receiver.
Installing Battery into Remote
1. Remove battery housing cover from back
of hand-held remote.
2. Install 3 AAA batteries.
3. Replace battery housing cover.
When batteries are installed, the "little house"
icon with current room temperature will be dis-
played (see Figure 34). This icon will always
show in the control window as long as the
batteries have power.
121308-01E
Battery Housing
Cover
Crossover
Log (#5)
Installing Battery into Remote Receiver
1. Open lower louver to gain access to
2. Remove screws from cover plate.
3. Remove battery housing cover.
4. Install 4 AA batteries.
5. Replace battery housing cover.
6. Replace cover plate.
7. Close louver panel.
Screws
Installing Cover Plate Onto Remote Receiver
1. Locate and remove cover plate from
2. Make sure sliding selector switch fits over
3. Attach cover plate to receiver with 2
4. See page 23 for instructions on program-
www.desatech.com
Figure 33 - Battery Install Hand-Held
Remote Control
Figure 34 - Remote Display
receiver.
Receiver
Battery Housing
Cover
Figure 35 - Battery Install Remote
Control Receiver
packaging.
switch on receiver.
screws as shown in Figure 35.
ming remote receiver to hand-held remote
control.
Note: For hand-held remote control to
work, programming (synchronizing) re-
mote to receiver must be completed.
-
AAA
+
-
AAA
+
-
AAA
+
Cover Plate
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cgefp33prcLmfp33nrcLmfp33prc

Table of Contents