Desa CGEFP33NRC Owner's Operation And Installation Manual page 18

Notches
Grate Finger
Figure 27 - Installing Front Log (#3)
(Base may vary from illustration)
Figure 28 - Installing Crossover Log (#4)
(Base may vary from illustration)
CGEFP33NRC and CGEFP33PRC Models
1. Locate pegs on bottom of back log (#1).
Slide these pegs into holes in grate base
behind burner (see Figure 29).
2. Place base of middle log (#2) in U-shaped
slots of grate base in front of back log.
Cutout on right of middle log should fit
over burner (see Figure 30). Make sure
front of middle log is resting on tabs of
grate base and cutout area is centered
over burner "U" bend.
3. Locate the notches in bottom of front
log (#3). Place front log on grate fingers.
Make sure notches of front log line up with
grate fingers (see Figure 31).
18
INSTALLATION
Continued
Front Log
(#3)
Crossover
Log (#4)
Peg
Recess
www.desatech.com
Hole in
Grate Base
Figure 29 - Installing Back Log (#1)
(Base may vary from illustration)
Tab
Burner
Figure 30 - Installing Middle Log (#2)
(Base may vary from illustration)
Notches
Grate
Fingers
Figure 31 - Installing Front Log (#3)
(Base may vary from illustration)
Back
Log (#1)
Middle
Log (#2)
Cutout
"U" Bend
U-shaped
Slot
Front Log (#3)
121308-01E