Programming Overview - Rangemaster RMB7248BL/SS User Manual

4.

Programming Overview

Fig. 4.1
3
2
1
4
3
2
1
Fig. 4.2
1
3
6 7
Oven Shelf levels
Always count shelf levels from the bottom upwards (Fig. 4.1)
When correctly installed, your product will meet
n
all safety requirements laid down for this type of
product. However, special care should be taken
around the rear or the underneath of the appliance
as these areas are not designed or intended to be
touched and may contain sharp or rough edges that
could cause injury.
NOTE: To receive the best out of your lower oven, we
recommend using only one shelf position and to use a dark
coloured tray no larger than 320 mm x 290 mm.
Setting the clock
The clock is preset to 12:00, and will revert to this after a
power failure. Press Menu (7) and press repeatedly untill the
clock indicator flashes (5), while the clock indicator flashes,
press '-' (6) or '+' (8) to set the time (Fig. 4.2). When you set
the correct time, the clock will set after approximately five
seconds delay and the indicator will disappear.
Minute minder
2
The minute minder can be used when the oven is switched
on or off. It can be set for up to 23 hours and 59 minutes.
4
To set the minute minder:
5
1. Press Menu (7) and press repeatedly untill the until the
minute minder indicator (5), (2) flashes (Fig. 4.2).
8
2. Then press either the '-' (6) or '+' (8) to select the
required duration for the minute minder (2). When
you have set the duration, touch Menu (7) or wait
for approximately five seconds. The minute minder
indicator (5) will relower lit to confirm the minute
minder is on.
3. When the countdown is complete, there will be an
alarm which will continue for two minutes and the
minute minder indicator will flash. To switch off the alert
beep, touch any key.
NOTE: The alarm will cut off after two minutes if it is not
switched off manually.
At the end of the countdown, the minute minder will
n
not switch off the oven. Remember to turn off the
oven manually.
5