Baby Monitor - Panasonic KX-TGD610 Operating Instructions Manual

Programming
Turning silent mode on/off
1
MMENUN#238
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
Changing the start and end time
1
MMENUN#237
2
Continue from step 3, "Turning silent
mode on/off", page 32.
Selecting groups to bypass silent
mode
1
MMENUN#241
2
MbN: Select the desired groups. a
MSELECTN
R " " is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN: Select the group. a Press
MSELECTN again. "
3
MSAVEN a MOFFN

Baby monitor

This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or even while away from home. The
monitored handset (placed in a baby's room,
for example) will automatically call the
monitoring handset or the phone number
stored when it detects sound.
For assistance, please visit http://shop.panasonic.com/support
32
TGD61x_63x(en)_0428_ver021.pdf 32
Important:
R Before using this feature, we recommend
that you test it and adjust the baby monitor
sensitivity as needed, especially if you plan
to monitor from outside.
R This feature should not be used as a
substitute for a medical or caregiver's
supervision. It is the caregiver's
responsibility to stay close enough to
handle any eventuality.
Note:
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored.
KX-TGD630 series (page 3): If the base
unit is placed near the monitored handset,
we recommend turning off the base unit
ringer volume (page 16).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby's room).
To monitor with a handset
The internal baby monitor feature is available
between handsets.
1
MMENUN#268
2
" disappears.
MbN: "On" a MSELECTN
3
MbN: Select the desired handset's number
to monitor with. a MSAVEN
R "Baby monitor" will be displayed.
R The registered handset's name/
Note:
R When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
number is displayed.
2021/04/28 11:28:13