Chapter 4 Connection; Ethernet Port; Sfp Port; Console Port - TP-Link JetStream T2500G-10MPS Installation Manual

Gigabit L2 Managed Switch

Chapter 4 Connection

4.1 Ethernet Port

4.2 SFP Port

4.3 Console Port

Connection
16
Connect the Ethernet ports of the switch to the network devices by RJ45 cable as
the following figure shows.
Figure 4-1 Connecting the RJ45 Port
RJ45 Port
Connect the SFP port to an SFP module. For the switch, if an SFP transceiver
(purchased separately) is installed in a slot and has a valid link on the port, the
associated RJ45 port will be disabled and cannot be used.
Figure 4-2 Inserting the SFP Module
CLI (Command Line Interface) enables you to manage the switch, thus you can load
the CLI after connecting the PCs or Terminals to the console port on the switch via
the provided cable.
Connect the Console (RJ-45) port of the device with your computer by the console
■
cable as the following figure shows.
RJ45 Cable
SFP Port
SFP Module