Table of Contents
Advertisement
Fault
Creasing.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
Cause
The load is too large.
The wrong programme is se-
lected for the type of fabric.
A low spin speed is selected.
is activated.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Unsuitable detergent added
to the dispenser of the intelli-
gent dosing system.
Troubleshooting en
Troubleshooting
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Centrif. programme.
▶
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Centrif. programme.
▶
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Centrif. programme.
▶
Start the Sköljning programme.
▶
Check whether the detergent used
1.
is suitable.
→ "Detergents and care products",
Page 38
63
Advertisement
Table of Contents
