Table of Contents
Advertisement
Fault
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Vibrations and movement of
the appliance whilst spin-
ning.
Heavy foam build-up
i-DOS cannot
i-DOS
be actuated.
High spin speed not
reached.
Cause
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Detergent dosage is too
high.
Intelligent dosing is not in-
tended for this programme.
Programme progress does
not allow intelligent dosing.
A low spin speed is selected.
is activated.
Troubleshooting en
Troubleshooting
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Do not add any extra water to the
▶
appliance while it is operating.
Not a fault – no action required.
▶
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the compartment for manual
dosing (not for outdoor clothing,
sportswear or items stuffed with
down).
If intelligent dosing is activated, re-
▶
duce the "basic dosage"
→ Page 43.
If you dose manually, reduce the
▶
amount of detergent for the next
washing cycle with the same load.
Not a fault – no action required.
▶
No remedial action possible.
The next time you run a wash cycle,
▶
set a higher spin speed.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
61
Advertisement
Table of Contents
