Table of Contents
Advertisement
¡ If you want to use both dispensers
for liquid detergent, adjust the
"contents of the dispenser"
→ Page 43.
Requirement: / flashes.
Pull out the detergent drawer.
1.
Open the dispenser lid.
2.
Pour liquid detergent and fabric
3.
softener
into the relevant dis-
pensers.
→ "Detergent drawer", Page 21
Close the dispenser lid.
4.
Note: To prevent the detergent
from drying out or drying up, do
not leave the dispenser lid open
for a long period of time.
Push in the detergent drawer.
5.
Adjust the "basic dosage"
6.
→ Page 43.
Intelligent dosing system en
Dispenser contents
When it leaves the factory, the dis-
penser is set for fabric softener
Alternatively, you can also use this
dispenser for a second liquid deter-
gent .
Notes
¡ If you change the content of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
Press and hold
1.
prox. 3 seconds.
To set , press
2.
a The display shows .
To set
, press
3.
To end the setting process, wait
4.
briefly.
Basic dosage
You can adjust the preset basic
dosages for liquid detergent and fab-
ric softener.
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
→ "Detergent dosage", Page 38
Adjusting the basic dosage
You can individually adjust the basic
dosages for each dispenser.
Press and hold
1.
prox. 3 seconds.
a The display shows the basic
dosage set for .
To adjust the setting, press
2.
.
i-DOS for ap-
i-DOS.
i-DOS again.
i-DOS for ap-
/
43
.
Advertisement
Table of Contents
