Table of Contents
Advertisement
PLPROFILE1 MKII LED Luminaires
FOCUS AND BEAM ADJUSTMENTS
1. Lens Tray Removal and Installation
It is easy and quick to change to the lens tray on a PLPROFILE1 MKII LED Luminaire. Zoomspot lens trays (as
shown in
"PLPROFILE1 MKII LED Luminaire Zoomspot Lenses" on page
To remove and install lens tubes:
Step 1. Before proceeding, it is recommended to move the zoom and focus lenses towards the center of the lens tray
assembly (away from the front and back edges).
Step 2. Unlatch lens tray as illustrated
supported.
PLPROFILE1 MKII LED Luminaire
Step 3. With lens tray assembly open (hanging down), lift lens tray assembly up and out of its hinged position to
free it from luminaire.
Step 4. To install perform process in reverse.
CAUTION: Ensure the lens tray assembly locking catch is fully engaged before putting fixture into use.
2. Zoom and Focus Adjustments
To adjust zoom/beam angle and focus:
Step 1. Make sure all frame shutters are open (out of beam path). See
more information.
Step 2. As shown in
Step 3. Hand-tighten Zoom Adjustment Knob to lock position.
Step 4. Loosen Focus Adjustment Knob.
Step 5. Move Focus Adjustment Knob along forward (or back) until beam focus is set as desired.
Figure
7. Be careful as the lens tray assembly will swing open if not properly
Figure 7: Lens Tray Assembly Removal
Figure
8, loosen Zoom Adjustment Knob and set beam angle as desired.
Installation & User's Manual
4) are interchangeable.
Lens Tray Assembly
Lens Tray Latch
"Beam Shutter Operation" on page 12
Lens Tray Removal and Installation
for
11
Advertisement
Table of Contents
