Mounting; Using Supplied C-Clamp - Philips Selecon PLPROFILE1 MKI Installation & User Manual

PLPROFILE1 MKII LED Luminaires

4. Mounting

WARNING! Before attempting any installation or service, disconnect all power at power source. Dimming the
luminaire does not disconnect power. Installation and service should only be performed by a trained and qualified
professional.

Using Supplied C-Clamp

As illustrated in
mounting hole at top of yoke, through Top Box Assembly, and thread bolt into C-Clamp. Securely tighten bolt (by
hand) into clamp (but do not over-tighten).
Note: Top box will be able to swivel once bolt is tightened by design. DO NOT OVER-TIGHTEN!
To mount on a telescopic stand, reverse the yoke under the luminaire and bolt to stand. Please note luminaire
orientation (see note in
Note: After installing Clamp and Top Box assembly, connect luminaire cable assembly to Top Box Assembly before
mounting luminaire. Please note that the cable connector is keyed.
Figure 5, at yoke assembly, thread clamp mounting bolt (with washer installed) through center clamp
Flat Washer
Flat Washer
C-Clamp Bolt*
Yoke Assembly
Figure 5: Luminaire Mounting
Figure 5) for proper cooling.
C-Clamp
Top Box Assembly
Center Clamp Mounting Hole (13 mm)
WARNING! *When installing a C-Clamp (or hook,
or other type of clamp) with the Top Box Assembly
as shown, you MUST use the C-Clamp Bolt
supplied with the fixture. Failure to do so may result
in damage to the Top Box Assembly or cause the
luminaire to dislodge from the clamping device.
Top Box Assembly
Luminaire Cable Assembly
NOTE: To allow for proper cooling, make sure
luminaire head is orientated as shown (with
cooling vents pointed upwards).
Installation & User's Manual
Mounting
9