Thermostat Operation - Emerson 1F85U-42PR Installation And Operating Instructions Manual

USER MENU
To customize thermostat settings, press the Menu button from the home screen. Use the
or buttons to highlight Settings and press Next. Use Next and Back to navigate
through menu items. Press or to change the setting.
User's Menu #
(Press Menu button Description
and release)
Schedule Type: set as either
01
7-Day, 5-1-1 Day or Non
Programmable
02
Defines periods per day
Early Start: starts heating
or cooling early so your
03
programmed temperature is
reached by the programmed
time
04
Fahrenheit or Celsius
Temperature Display
05
Adjustment: adjust the Room
Temperature)
Continuous Display Light:
06
keep the backlight always on –
"C" wire required
07 Change Air Filter: set up a
monthly reminder
Auto-Changeover: thermostat
08
automatically switches between
heat and cool

THERMOSTAT OPERATION

Set Current Time and Day
Note: Time icons will flash at initial power up or after a reset.
1.) Press Menu
2.) The time icon will be flashing, Press Next to advance and set the time
3.) Use or to set the correct time
4.) Press Next and use or to set the correct day
5.) Press Exit when finished.
The default program is 5-1-1 Day, but can be setup as a 7-Day or Non-Programmable
thermostat (refer to the User Menu above)
• Hold Temperature (bypassing the schedule) – With the System set to Heat or Cool,
momentarily press the Hold/Run button. Hold will be displayed. Use
temperature. The thermostat will hold the room temperature at the selected setting until
you press Hold/Run again to start program operation (cancels permanent Hold).
• Program Override (Temporary Hold) – Press
displayed. The thermostat will override the schedule until the next programmed time
period with a minimum override of 2 hours. Then the thermostat will automatically revert
to the program.
• Keypad Lockout – To prevent unwanted changes, the buttons can be disabled.
To turn this feature On, press and hold
turn Off, press and hold and the Menu button for 3 seconds.
6
Default Setting Settings
(flashing icons) (Press or )
7 – 7 Day
5 5 – 5-1-1 Day
0 – Non-Programmable
2 - leave, return
4
4 - wake, leave, return, sleep
On – start early
OFF OFF – start at program
period time
°F – Fahrenheit
°F
°C – Celsius
0 -5 to +5
On – always on
OFF
OFF – momentarily
1 to 12 – reminder time
OFF (months)
OFF – no filter reminder
On - enable auto
OFF
OFF - disable auto
or to adjust the
or until the desired temperature is
and the Menu button until the icon appears. To