Wells HC125 Owner's Manual page 6

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation. Refer to
SHIPPING DAMAGE CLAIM
PROCEDURE on the inside
front cover of this manual.
CAUTION:
ELECTRIC SHOCK
HAZARD
The ground prong of the
power cord is part of a system
designed to protect you from
electric shock in the event
of internal damage to the
appliance.
NEVER CUT OFF THE
GROUND PRONG (large
round prong). NEVER
TWIST A PRONG TO FIT AN
EXISTING RECEPTACLE.
Contact a licensed electrician
to install an electrical
receptacle appropriate to
the voltage and amperage
requirements of the hotplate.
IMPORTANT:
Damage due to being plugged
into the wrong voltage or phase
is NOT covered by warranty
UNPACKING & INSPECTION
Carefully remove the hotplate from the carton. Remove all protective
plastic film, packing materials and accessories from the hotplate
before plugging the hotplate into electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the hotplate before starting any
installation.
Read and understand all labels and diagrams attached to the hotplate.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Supplied legs must be properly installed.
Setup the hotplate only on a firm level surface. Non-combustible
material (e.g. metal, terrazzo) is recommended.
Maintain at least 1" from adjacent surfaces.
ELECTRICAL
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Connecting the
hotplate to the wrong voltage can severely damage the equipment or
cause noticeably decreased performance.
Hotplate is equipped with a grounded electric power cord, this cord
must be plugged into a properly grounded electrical receptacle.
6