Lennox Hearth Products SUPERIOR SVFS32NEVF Owner's Operation And Installation Manual page 18

INSTALLATION
Fri 20:45
OFF
On
Figure 28 - Main Screen
After 40 seconds, the configuration menu
appears (see Figure 29). With ''Pairing'' high-
lighted press the middle ''select'' button. ''Off''
becomes highlighted (see Figures 29 and 30).
f i r e - p a r t s . c o m
Fri 22:04
Configuration
Pairing
Thermostat
Gap Temp
Programming
Select Back
Figure 29 - Configuration Menu
Fri 21:47
Configuration
Off Pairing
Yes
Thermostat
0.5°C Gap Temp
No Programming
Change
Figure 30 - Off Highlighted
18
Continued
Fri 22:04
Configuration
Pairing
75
Thermostat
°F
Gap
Programming
Lock Menu
OFF
Button
Fri 21:47
Off Pairing
Yes
Thermostat
0.5°C Gap
SELECT
No Programming
Change
Button
Off
Yes
0.5°C
Yes
Back
www.lennoxhearthproducts.com
IMPORTANT! Be prepared to press the S1
button as noted in the beginning of this sec-
tion. After the next step, you have only 20
seconds to push (press and release) the S1
button (yellow/orange) in the control module
(see Figure 24, page 17).
Off
Yes
Temp 0.5°C
No
Select Back
Change
Button
NOTE: The control module may be turned dif-
ferently than shown in this figure. Look for the
matching text on the control module to help
locate the small yellow / orange S1.
Press the left "Change" button and "Off" becomes
Configuration
"On" (see Figure 31, above). Press the S1 but-
Off
Yes
ton to re-pair the remote to the control module.
Temp 0.5°C
Once this operation is done, you will hear one
Yes
Back beep in the control module and the configura-
tion menu will show signal bars:
Figure 32, page 19). If you do not hear the beep
and then see signal bars within 30 seconds of
hearing the beep, then the repairing process
was not completed successfully. If this occurs,
remove the batteries from the remote control,
wait 3 minutes, and restart the re-pairing pro-
cess. If you see signal bars, then the remote
control has paired properly. Go to the next step.
Fri 22:04
Configuration
Pairing
Thermostat
Gap Temp
Programming
Change
Figure 31 - Change OFF to ON
Fri 22:05
Configuration
Pairing
Thermostat
Gap Temp
Programming
Change
Figure 32 - Signal Bars
On
Yes
0.5°C
No
Back
(see
Fri 22:05
Configuration
Pairing
Off
Thermostat
Yes
Gap Temp
0.5°C
Programming
No
Select Back
Back
126544-01A
Off
Yes
0.5°C
No