Table of Contents
Advertisement
Changing programme default settings
en
Starching
The laundry should not be
Note:
treated with fabric softener.
Liquid starch can be used in all wash
programmes. Pour starch into the
dispenser M according to
manufacturer's specifications
(if required, clean beforehand).
Dyeing/Bleaching
Dye in household quantities only. Salt
may attack stainless steel! Observe
specifications of the dye manufacturer!
Do not bleach laundry in the washer
dryer!
Soaking
Pour soaking agent/detergent into
1.
compartment II in accordance with
the manufacturer's instructions.
Set the programme selector to
2.
algodón/algodão (Cottons) 30 °C
programme.
Select inicio/pausa+carga (Start/
3.
Reload) !.
After approx. ten minutes, select
4.
inicio/pausa+carga (Start/Reload)
!.
After the required soaking time,
5.
select inicio/pausa+carga (Start/
Reload) ! again to continue or
change the programme.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
24
0
Changing programme
default settings
You can change the default settings for
C h a n g i n g p r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The default
settings can be changed even while the
selected programme is running. The
effects depend on the progress of the
programme.
temp.°C (Temperature)
( The indicated washing temperature
can be changed. The maximum
selectable washing temperature varies
depending on the selected programme.
Overview of programmes ~ Page 20
0 (Spin speed)
0 The spin speed can be changed
before and during the programme (in
rpm, revolutions per minute) depending
on the progress of the programme.
Setting – – – (Rinse stop = without final
drain/spin cycle), laundry remains in the
water after the last rinse cycle. The
maximum spin speed depends on the
programme and model.
Overview of programmes ~ Page 20
Advertisement
Table of Contents
