Reloading The Laundry; Changing The Programme; Interrupting Or Ending The Programme - Siemens WD15H547EP Instruction Manual

Operating the appliance
en
w lights up: The childproof lock is
■
activated.
w flashes: The childproof lock is
■
active and the programme selector
has been adjusted. To prevent the
programme from terminating, reset
the programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.

Reloading the laundry

When the programme has started, the
laundry can be reloaded or taken out as
required.
Select inicio/pausa+carga (Start/
Reload) !. The washer dryer checks
whether a reloading is possible.
Notes
If there is a high water level, high
■
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
A:02 + PAUS ~ Reloading is not
possible. To continue the
programme, select the Start/Reload
! button.
v + OPEN are lit ~ Reloading is
possible.
Do not open the door until both the
■
symbols v + OPEN are lit.
Do not leave door open for
■
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
■
activated during the drying phase.
18

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select inicio/pausa+carga
1.
(Start/Reload) !.
Select another programme. If
2.
required, adjust the default settings
and/or select other additional
funtions.
Select inicio/pausa+carga (Start/
3.
Reload) !. The new programme
starts from the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
Select inicio/pausa+carga
1.
(Start/Reload) !.
To cool down laundry: Select
2.
q (Rinse).
Select inicio/pausa+carga (Start/
3.
Reload) !.
For programmes at low temperature:
Select inicio/pausa+carga
1.
(Start/Reload) !.
Select 0 (Spin)/p (Empty).
2.
Select inicio/pausa+carga (Start/
3.
Reload) !.
For drying programmes:
Select secar normal (Intensive Dry)
1.
or secar delicado (Low Heat Dry).
Press button secar (Drying) Ù, and
2.
set drying time to 15 min.
Select inicio/pausa+carga (Start/
3.
Reload) !.