Ice Tray - Hitachi R-G500GS How To Use Manual

Ice tray

Once or twice a year
Touch button on the Control Panel to turn on
1
the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
2
Touch
It stops water supply to the ice tray.
※ When " Off " indicator lamp blinks, wait for about 1 minute for it to turn on, and then follow the next
steps.
Note that the frame cannot be pulled out.
3
Open the door of the Ice Compartment, and take out the ice tray.
R-G500G type
Push the level laterally.
Raise the cover ( ▲ part) in the direction of the arrow.
Remove the ice tray from the frame.
Ice tray
Cover
4
Empty the ice tray and wash it lightly in the stream.
Do not use a sponge / cleanser, etc.
Be sure not to scarify.
5
Open the Ice Compartment, and then attach the ice tray.
R-G500G type
Set the ice tray
Hold down the cover to the end until it snaps.
Push the frame to the end until it snaps.
Move the frame back and forth to check that it is fixed securely.
● When the frame for the ice tray cannot be pushed into the back, the motor that drives the ice-tray may have operated. Remove
Notice
6
Touch button on the Control Panel to turn on the
indicator lamp, and then touch
" On " indicator lamp.
Automatic Ice Making starts.
button to turn on " Off " indicator lamp.
draw the frame.
Slide
Lever
Frame
Click
Click
the ice tray once and then push the frame alone into the back, and then touch
" Off " . After 1 minute, the ice-tray driving motor gets ready, allowing you to mount the ice-tray.
R-G420G type
Push the level laterally.
Raise the cover ( ▲ part) in the direction of the arrow.
Remove the ice tray from the frame.
Ice tray
Cover
R-G420G type
Set the ice tray and
close the cover.
Make the frame horizontal and push it into the end, and
Pull up the lever.
(Move the frame back and forth to check that it is fixed securely.)
Is the lever in
horizontal state?
button to turn on the
Touch it
draw the frame.
Lever
Frame
Click
Click
Horizontal
button with all the doors closed to turn on
Touch it
63