Section 3: Operation; Site Prep Verification; Generator Enclosure; Opening The Lid - Generac Power Systems G0071411 Owner's Manual

Section 3: Operation

Site Prep Verification

DANGER
Automatic start-up. Disconnect utility power and
render unit inoperable before working on unit.
Failure to do so will result in death or serious injury.
The generator must be installed to allow proper airflow.
Mechanical and gravity outdoor air intake openings for air
distribution and supply systems must be located no less
than 10 ft (3.0 m) horizontally from the generator enclosure.
See Section 401.4 in the ICC Mechanical Code for
additional information.
Verify all shrubs or tall grasses within 3 ft (0.91 m) of the
intake and discharge louvers on sides of the enclosure
have been removed. Install generator on high ground
where water levels will not rise and endanger it. This unit
should not operate in or be subjected to standing water.
Verify all potential water sources such as water
sprinklers, roof run-off, rain gutter downspouts, and sump
pump discharges are directed away from the generator
enclosure.
A
B
Owner's Manual for 60 Hz Air-Cooled Generators
(000191)
A
Figure 3-1. Side Lock Location and Front Panel Removal

Generator Enclosure

Enclosure lid is locked prior to shipment. A set of keys is
attached to the cardboard on top of the generator when it is
shipped. An additional set of keys is attached to the pallet
bracket on the front intake end of the generator.
NOTE: The enclosed keys provided with this unit are
intended for service personnel use only.

Opening the Lid

Two locks secure the lid—one on each side (A in
3-1). Open protective rubber cap to access keyhole, and
press down on lid above the side lock and unlock the
latch to properly open the lid.
Repeat for other side. Lid may appear stuck if pressure is
not applied from the top.
Always verify side locks are unlocked before attempting
to lift lid.

Front Access Panel Removal

Remove front access panel by lifting it straight up and
away once the lid is open.
Always lift front access panel straight up before pulling it
away from the enclosure (B and C in
pull panel away from the enclosure before lifting up (D in
Figure 3-1).
C
Operation
Figure
Figure 3-1). Do not
D
001797
13