Table of Contents
Advertisement
v FC 6672: Power Cord (9-foot), Drawer to IBM PDU, 250V/10A
v FC 6671: Power Cord (5-foot), Drawer to IBM PDU, 250V/10A
The previous features are only available for use in racks less than 25U in size.
6. Use an Ethernet cable to connect the 7036-P16 to the network.
7. Connect serial devices as needed.
Installing Digi RealPort software for the 7036-P16 device
You might need to install the Digi RealPort software on an AIX or Linux host server. Use the procedure
in this section to perform this task.
Digi RealPort software-support packages
The following is a list of the software packages available on the software CD provided with the 7036-P16
unit:
v The Digi RealPort software package for AIX supports the following AIX levels:
™
– AIX 5L
5.2.0.75 (and later)
– AIX 5L 5.3.0.30 (and later)
v The Digi RealPort software package for Linux supports the following Linux levels:
– Linux Red Hat Version RHEL4, Update 3
– Linux SUSE Version SLES 9 SP2
Installing the Digi RealPort software
To install the Digi RealPort software, do the following steps:
1. Install all updates and packages required to bring the operating system to the supported levels.
2. Install all Linux packages required to compile and create binaries from the Digi RealPort Software
source code.
The following is a list of Linux packages that are required to install the Digi RealPort software:
v gcc
v gcc-64bit
v gcc-c++
v gcc-g77-64bit
v gcc-info
v gcc-locale
v gcc-objc
v gcc-objc-64bit
v kernel sources
v glibc-devel-64bit
v ncurses-64bit
v ncurses-devel
3. Install the Digi RealPort software. To install the software, see the following procedures.
Installing the AIX Digi RealPort software
To install the software package for the AIX environment, do the following steps:
1. Log in to the host server as the root user.
2. Insert the CD-ROM into the CD-ROM drive.
3. Type the following command: smitty install_all
96
Managing devices
Advertisement
Table of Contents
