Wolf OG42LP Installation Manual page 9

IN S TA L L AT I O N
Gas Supply Line
N AT U R A L G A S CO NNE C T I O N
Install the natural gas pressure regulator supplied with the
outdoor product with the arrow on the regulator pointing
towards the unit. Refer to the illustrations below for a typical
natural gas installation.
REGULATOR
REAR GAS
CONNECTION
BOTTOM GAS
CONNECTION
SHUT-OFF
VALVE
Natural gas connection
ADAPTER
VENT CLOSE
NIPPLE
FROM GAS
TO GRILL SUPPLY
REGULATOR
Natural gas regulator
LP GAS C O N N EC TIO N
For whole house LP gas connection, the LP gas pressure
regulator is not provided. It can be purchased from an
authorized Wolf dealer. For local dealer information, visit the
find a showroom section of our website, wolfappliance.com.
For connection to LP gas cylinder, use only the LP gas pres-
sure regulator and hose supplied with the outdoor product.
Use only a 20-lb LP gas cylinder with an approved overfilling
preventive device (OPD) and shut-off valve terminating in
the cylinder valve outlet.
Connect the 3 / " flare end of the hose to the unit cou-
1
8
pling. Do not apply pipe sealant to the flare connection.
Install the LP gas cylinder, pull out the shelf and place
2
the cylinder on it. Refer to the illustration below.
Ensure the gas valve on top of the cylinder is closed.
3
Connect the LP gas regulator to the cylinder and hand-
4
tighten only. Open the cylinder valve. Check for gas
leaks. Refer to the illustration below.
Tighten the LP tank retention screw to secure the cyl-
5
inder to the shelf.
WARNING
Perform a gas leak test each time the LP gas cylinder is
changed. Do not place more than one LP gas cylinder
in an enclosure at a time.
LP TANK
RETENTION SCREW
LP tank shelf
GRILL
COUPLING
COUPLING VENT
NUT
TO GRILL
REGULATOR
LP gas cylinder connection
|
wolfappliance.com 9