Wolf OG42LP Installation Manual page 13

IN S TA L L AT I O N
Side Burner Installation
IN S TA L L S I DE BU RN E R S H R O U D
Side burner is placed inside shroud for shipping. Lift out
1
to remove side burner from shroud.
Hang shroud by hand-starting four 10-32 machine
2
screws provided through upper slots of shroud, into
upper holes of cart. Do not fully tighten screws until
shroud is properly aligned. Refer to the illustration below.
Place alignment tool provided with lip placed in the gap
3
between the grill and shroud as shown in the illustration
below.
To align front of shroud, push alignment tool back until
4
center block of tool is flush against front vertical flange
of shroud.
Align front of shroud (up and down) with alignment tool
5
until top of tool is flush with top surface of grill bullnose.
Align shroud (front to back) with tool until front of tool is
flush with front of bullnose. Tighten upper screw. Refer
to the illustration below.
SCREWS
SCREWS
Hang shroud
ALIGNMENT
TOOL
UPPER
SCREW
SURFACES
FLUSH
Align front of shroud
To align back of shroud, place alignment tool at rear of
6
shroud. Align rear of shroud (up and down) with tool until
top of tool is flush with top surface of grill. Tighten upper
screw. Refer to the illustration below. Verify with align-
ment tool that front of shroud did not move, realign if
necessary.
Remove alignment tool and tighten two remaining
7
screws to slots just below the upper screws.
5 3
Install two / x / hex drive shoulder screws provided
8
16 8
into lower holes of shroud and through cart. Place two
1 / –20 hex nuts from inside of cart and tighten. Refer to
4
the illustration below.
SURFACES
FLUSH
ALIGNMENT
UPPER TOOL
SCREW
Align back of shroud
SHOULDER
SCREWS
HEX NUT
(INSIDE CART)
Secure shroud
|
wolfappliance.com 13