Error Messages; Operation Beep - Brother CS-8070 Operation Manual

S2_brotherE.book Page 106 Thursday, February 13, 2003 11:03 AM
APPENDIX ——————————————————————————————————————————————————————————

Error messages

If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed
incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear.
If you press (Stitch selection key) or do the operation correctly while the error message is displayed, the
message disappears.
Error Message

Operation beep

Each time a key is pressed or an incorrect operation
is performed, a beep is sounded.
I For a correct operation
One beep is sounded.
I If an incorrect operation is performed
Two or four beeps are sounded.
I If the machine locks up, for example, because
the thread is tangled
The sewing machine continues to beep for four
seconds. The machine automatically stops. Be
sure to check for the cause of the error, and
correct it before continuing to sew.
106
Probable Cause
The start/stop button, reverse/reinforcement stitch button
or thread cutter button was pressed while the presser
foot was raised.
A stitch other than the buttonhole or bar tack stitch was
selected and the start/stop button was pressed while the
buttonhole lever is lowered.
The buttonhole or bar tack stitch was selected and the
start/stop button was pressed while the buttonhole lever
is raised.
The reverse/reinforcement stitch button, needle position
button or thread cutter button was pressed while the
bobbin winder shaft is moved to the right.
The start/stop button was pressed while the foot control-
ler was connected.
The motor locked up because the thread is tangled.
The start/stop button, reverse/reinforcement stitch button
or the thread cutter button was pressed while no thread
cassette was installed.
You tried to start sewing while the needle is lowered.