Table of Contents
Advertisement
7. Operation
OP1
(1)
OP2
(4)
(5)
OP3
(6)
OP4
[HTZ2500]
[CHTZ2500]
16
(2)
(3)
STARTING ENGINE
WARNING
The cutting head will start rotating upon the
engine starts.
1. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
2. Push the primer pump several times until
overflown fuel flows out in the clear tube. (OP1)
3. Move the choke lever to the closed position.
(OP2)
4. Set the ignition switch to the "START" position.
(OP3)
(1) primer pump
(2) choke lever
(3) close
(4) open
(5) ignition switch
(6) throttle lever
5. Holding the hedge-trimmer down, pull the
starting rope slowly until you meet resistance
(OP4). Then operatel hard several times, and
when the engine starts, wait for about 10
seconds and then pull the throttle lever (OP3(6)),
the choke lever (OP2(2)) will return automatically
to the original "OPEN" position.
WARNING
Use the semi-acceleration device only in the
phase of starting the engine.
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause
starter failures.
Advertisement
Table of Contents
