Remote Control Button - Panasonic CS-XZ20XKEW-H Service Manual

17.3 Remote Control Button

17.3.1 SET Button

To check remote control transmission code and store the transmission code to EEPROM.
Press "Set" button by using pointer.
o
Press "Timer Set" button until a "beep" sound is heard as confirmation of transmission code change.
o
LCD returns to original display if remote control does not operate for 30 seconds.
o
OR
OR
OR
Press SW, special setting is immediately cancelled and normal mode starts.
CANCEL
o
If no SW is pressed for 30 secs, then special setting mode is cancelled and normal mode starts.
o
Under this function, only
o
Normal display mode
SET
If jumper JA=Short & JB=Open
RC number = A
If jumper JA=Open & JB=Open
RC number = B
If jumper JA=Short & JB=Short
RC number = C
If jumper JA=Open & JB=Short
RC number = D
, ,
SET
SET
and SW's are effective.
CANCEL
99
Transmit
"Remote control no." code