Table of Contents
Advertisement
STEP 4 INSTALL CASE TRIM
Install case trim using supplied right hand and left hand
case trim pieces and case trim screws. Attach case trim
to each side of case as shown in illustration using case
trim screws in holes provided down each side of case.
STEP 5 INSTALL ANTI-TIP BRACKET
WARNING
The unit is top-heavy and must be secured to prevent the
possibility of tipping forward.
AVERTISSEMENT
L'appareil ménager est beaucoup plus lourd en haut et il
faut le maintenir en place pour éviter la possibilité de son
basculement vers l'avant.
Flush Installation Only
• Cut a 1/2" x 4" block, 35" long.
• Measure and mark under the soffit,
5-1/4" from the front edge of the
cabinet.
• Secure the wood block to under the
soffit. From the bottom of the block
to the finished floor should measure
84". See the illustration.
Installation Instructions
Tip Over Hazard.
Risque de basculement
STEP 5 INSTALL ANTI-TIP BRACKET
(cont.)
Standard/Stainless Installation Only
• The kit supplied with the unit contains 2 lag bolts and 4
toggles with bolts. The wall bracket will be attached to
the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" from the floor. Mark this point on
the wall.
• Using a level, draw a horizontal line on the wall at this
height.
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
• Place the bottom of the wall bracket with tabs on the
horizontal line. Align the center notch on the bracket
with the center line on the wall.
• The anti-tip wall bracket has a series of holes. Select 2
holes that match with the located studs. Make sure the
holes selected are on the center of the studs. Mark the
wall at these points.
16
Advertisement
Table of Contents
