Table of Contents
Advertisement
2
Ejecting the Battery
Slide and hold the Battery Eject Lever
the direction shown by the arrow
2
battery to eject
.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
≥When recharging, turn off the power of the printer.
≥Remove the battery if the printer is left unused for a
long time.
≥When the battery is fully charged, up to 24 sheets
can be printed in succession when the ambient
temperature is 77 degrees F/25 degrees C.
≥Typical charging time to fully charge the battery is
about 170 minutes (68 degrees F/20 degrees C and
humidity 60 %). Higher or lower ambient
temperature may cause a variation in the actual
charging time.
≥When the Power Lamp flashes more quickly or
slowly (or turns off), some abnormality may have
occurred. Refer to "State of Power Lamp While
Charging" on page 46.
2
toward
1
and slide the
9
Advertisement
Table of Contents
