Ryobi Airwave RA-C2550-G Operator's Manual page 8

not be used for a while, it is best to leave drain valve
open until such time as it is to be used. This will allow
moisture to completely drain out and help prevent
corrosion on the inside of tank.
■ Risk of fire or explosion. Do not spray flammable liquid
in a confined area. Spray area must be well ventilated.
Do not smoke while spraying or spray where spark or
flame is present. Keep compressors as far from the
spraying area as possible, at least 10 m (33 feet) from
the spraying area and all explosive vapors.
■ Risk of bursting. Do not adjust regulator to result
in output pressure greater than marked maximum
pressure of attachment. Do not use at pressure
greater than 8 bar.
■ If connected to a circuit protected by fuses, use time
delay fuses with this product.
■ To reduce the risk of electric shock, do not expose to
rain. Store indoors.
■ Inspect tank yearly for rust, pin holes, or other
imperfections that could cause it to become unsafe.
■ Never weld or drill holes in the air tank.
■ Make sure the hose is free of obstructions or snags.
Entangled or snarled hoses can cause loss of balance
or footing and may become damaged.
■ Use the air compressor only for its intended use. Do
not alter or modify the unit from the original design or
function.
■ Always be aware that misuse and improper handling
of this product can cause injury to yourself and others.
■ Never leave a tool unattended with the air hose
attached.
■ Never point any air tool toward yourself or others.
■ Do not operate this air compressor if it does not
contain a legible warning label.
■ Do not continue to use a tool or hose that leaks air or
does not function properly.
■ Always disconnect the air supply and power supply
before making adjustments, servicing a product, or
when a product is not in use.
■ Do not attempt to pull or carry the air compressor by
the hose.
■ Your tool may require more air consumption than this
air compressor is capable of providing.
■ Always follow all safety rules recommended by the
manufacturer of your air tool, in addition to all safety
rules for the air compressor. Following this rule will
reduce the risk of serious personal injury.
■ Never direct a jet of compressed air toward people or
animals. Take care not to blow dust and dirt towards
yourself or others. Following this rule will reduce the
risk of serious injury.
■ Do not use this air compressor to spray chemicals.
Your lungs can be damaged by inhaling toxic fumes.
A respirator may be necessary in dusty environments
or when spraying paint. Do not carry while painting.
■ Inspect product cords and hoses periodically and,
if damaged, have them repaired at your nearest
authorised service center. Constantly stay aware of
cord location. Following this rule will reduce the risk of
electric shock or fire.
■ Never use an electrical adaptor with this grounded
plug.
■ Check for damaged parts. Before further use of the
air compressor or air tool, a guard or other part that
is damaged should be carefully checked to determine
that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A
guard or other part that is damaged should be properly
repaired or replaced by an authorized service center.
Following this rule will reduce the risk of serious injury.
■ Never store a tool with an air line connected. Storing
the tool while connected to an air supply can result
in unexpected operation, firing or movement and
possible serious personal injury.
■ Protect your lungs. Wear a face or dust mask if the
operation is dusty. Following this rule will reduce the
risk of serious personal injury.
■ If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
service centre to avoid risk.
■ Save these instructions. Refer to them frequently and
use them to instruct others who may use this product.
If you loan someone this product, loan them these
instructions also.
■ the machine shall be connected to a circuit
protection device (fuse or circuit breaker).
■ Operate the machine from the front of the control
panel.
■ When the machine is in operation, many parts
of machine may cause a high temperature. Use
necessary personal
as gloves to avoid injuries resulting from a high
temperature.
■ this machine is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge. children should be supervised to
ensure that they do not play with the machine.
2
protection equipment such