Table of Contents
Advertisement
OPTIONAL OPERATION
18
Installer Setting - Setting Address of Central Control
It's the function to use for connecting central control.
Please refer to central controller manual for the details.
FAN
SPEED
TEMP
• If you connect the indoor unit to the central controller, you should set the network address
of the indoor unit so that the central controller could recognize it.
• The center-control address is composed of the group number and the indoor-unit number.
Note : The remote controller displays 'HL' if central controller has locked the remote controller .
* In the case when the lock is set up at the central controller, 'HL' will be indicated on the display
window of the wired remote controller and the indoor unit will not be controlled by the remote
controller.
1
2
OPER
MODE
3
4
When pressing the
button and
simultaneously for more than 3 seconds, the
system will be entered into the installer setting
mode.
- After entering into the installer setting mode,
select the central control address setting code
value by pressing the
OPER
MODE
* Setting address of central control code value
: 02
Set up the group nember and indoor unit with
the temperature adjustment(▲,▼) buttons.
Group number
TEMP
Indoor unit number
For example, when setting as
[ Group number=2
it will be displayed as shown in the left figure.
When pressing the
button, the system will
be set up with the address value which has
been established at present.
When pressing the
button simultaneously for more than 3 seconds
after the setting has been completed, the
setting mode will be released.
- If there isn't any button input for more than
25 seconds, the installer setting mode will
also be released.
OPER
button
MODE
button.
Indoor number=3 ]
button and
OPER
MODE
Hide quick links:
Advertisement
Table of Contents
