Figure 3 Re-Route Wires For Left Hand Units - Bard CRVP-5L Installation Instructions Manual

5. For Installation of Left Hand Units Only – Remove
strain relief in right side of CRVS. Unclip the (2)
wire ties holding the wire harness. Reroute wires to
left side of CRVS. Reinstall wire ties in left side
holes. Route wires through left side and reinstall
strain relief. (See Figure 3.)
REROUTE WIRES FOR LEFT HAND CRVS-5 UNITS ONLY (CRVS SHOWN)
Manual 2100-458F
Page 6 of 18
6. Install ventilator by inserting the ventilator into the
unit to the far left side clearing the right filter
bracket. Once the ventilator is fully inserted, slide
the ventilator to the right until it is tight against the
back of the control panel. (See Figure 4.)
FIGURE 3