Figure 3 Re-Route Wires For Left Hand Units - Bard CRVS-5 Installation Instructions Manual

5. For Installation of Left Hand Units Only – Remove
strain relief in right side of CRV. Unclip the (2)
wire ties holding the wire harness. Reroute wires to
left side of CRV. Reinstall wire ties in left side
holes. Route wires through left side and reinstall
strain relief. (See Figure 3.)
Manual 2100-458C
Page 6 of 17
FIGURE 3
REROUTE WIRES FOR LEFT HAND UNITS ONLY
6. Install ventilator by inserting the ventilator into the
unit to the far left side clearing the right filter
bracket. Once the ventilator is fully inserted, slide
the ventilator to the right until it is tight against the
back of the control panel. (See Figure 4.)