Information; Fcc Statement - Belkin F7D2101V1 User Manual

InfOrMaTIOn

fCC Statement

deClaraTIOn Of COnfOrMITY WITH fCC rUleS
fOr eleCTrOMagneTIC COMPaTIbIlITY
We, Belkin International, Inc ., of 12045 Waterfront Drive, Los
Angeles, CA 90094, declare under our sole responsibility that the
product, F7D2101v1, to which this declaration relates, complies with
Part 15 of the FCC Rules . Operation is subject to the following two
conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation .
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.
IMPORTANT NOTE:
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled
exposure limits in ANSI/IEEE C95.1-1999 and had been tested in
accordance with the measurement methods and procedures specified in
OET Bulletin 65 Supplement C. This equipment should be installed and
operated with minimum distance 1.5 cm between the radiator and your body.
federal Communications Commission notice
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules . These limits are designed to provide reasonable protection
against harmful interference in a residential installation .
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur
in a particular installation . If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.
32