Vitodens 200-W B2HB 19 to 35, 68 to 125 Installation
Wall Mounting
Fitting the wall mounting bracket
Following are the installation instructions for the mounting
bracket on each material. See the instructions applicable
to your installation requirements.
Installing the wall mounting bracket
The Vitodens 200-W B2HB can be wall-mounted on a
concrete wall.
Note: The enclosed screws and plastic anchors are
only suitable for concrete. For other construction
materials, use bolts and anchors that are suitable
for 115 lb (52 kg) loads.
Installation of mounting bracket on brick/concrete wall
1. Drill holes 7
/
in. (12 mm).
31
64
2. Install rawl plugs and screw mounting bracket
to wall.
3. Ensure the mounting bracket is level.
CAUTION
Whichever mounting method is used, ensure that the
bracket is tightly and securely fastened to wall. Failure
to secure boiler properly could cause boiler to loosen,
posing a severe safety hazard.
Boiler Connections
13