Advertisement
2
Installing the Rear Hitch
Parts needed for this procedure:
1
Rear hitch
2
Bolt (5/16 x 1 inch)
2
Locknut (5/16 inch)
Procedure
Install the bracket to the frame as shown in
3
and
Figure
4.
Before assembly
1. Bolt
2. Bracket
After assembly
Figure
Figure 3
3. Locknut
Figure 4
3
Setting Up the
Motion-Control Levers
CE Machines Only
No Parts Required
Procedure
1.
Locate the motion-control levers attached, but
folded down on the machine.
2.
Remove the upper bolt (3/8 x 1 inch) and
washer; loosen the lower bolt (3/8 x 1 inch).
3.
Raise the motion control levers to the upright
position.
4.
Align the holes in the motion-control lever with
the holes in the control-arm shaft, and install the
bolt and washer removed previously. Repeat
this for both controls levers.
Note:
Hand tighten all fasteners.
5.
Move the motion-control levers to the park
position, raise the seat, and move the control
levers back to the center position (neutral).
g191160
6.
Verify that the motion-control levers are properly
aligned.
Note:
Adjust as necessary. Tighten all
fasteners.
4
Checking the Mower
Adjustment
No Parts Required
g191159
Procedure
Adjust the side-to-side level and the front-to-rear blade
slope. Use the relevant procedures in the Operator's
Manual to verify that the deck is level, and make any
adjustments as necessary. Refer to the Operator's
Manual for more information.
3
Advertisement
