Advertisement
Fax Problems
Problem
?
I DON'T KNOW HOW TO FORWARD
RECEIVED FAXES
I DON'T KNOW HOW TO PREVIEW
RECEIVED FAXES
NOTIFICATION SOUNDS ARE TOO
LOUD OR TOO SOFT, OR ARE NOT
AUDIBLE (VOLUME ADJUSTMENT)
I DON'T KNOW HOW TO STORE OR
PRINT SENDER INFORMATION
BROADCAST TRANSMISSION
DOES NOT WORK
THE DATA NOTIFICATION
INDICATOR DOES NOT TURN OFF
I DON'T KNOW HOW TO CHECK AN
ADDRESS WHEN SENDING A FAX
TRANSMISSION DOES NOT TAKE PLACE
?
Check
Is the telephone line connected
securely?
Is the correct dial mode set for your
line?
Is a busy signal received?
Did a communication error occur?
Check
Use the received fax forwarding settings in setting mode.
Enable the image preview setting for received faxes in setting mode.
Have you adjusted the volume in the speaker settings of setting mode?
You can adjust the volume of the original scan complete sound in the
scan complete sound setting of setting mode.
You can store sender information in "Own Name and Destination Set" in
setting mode.
Has broadcast setting been disabled in the setting mode
(administrator)?
Did you retrieve a received fax that was printed?
Is an error preventing received faxes from being printed?
Tap the [Address Review] key.
Is "Fax Dest. Confirmation Mode" enabled in setting mode?
!
Solution
■ Check the telephone line jack, the wall jack, and any extension adapters to make
sure that all connections are secure.
► Power and connector positions (page 4)
■ Ask your administrator to verify that "Dial Mode Setting" is set correctly for the
line you are using.
Select the telephone line type in "Dial Mode Setting" in the setting mode (administrator).
"Settings" → [System Settings] → [Image Send Settings]
→ [Fax Settings] → [Condition Settings] → [Dial Mode Setting]
■ If a busy signal is received, the transmission is temporarily canceled and then
automatically attempted again after a brief interval. The factory default setting :
Two attempts at 3-minute intervals.
"Settings" → [System Settings] → [Image Send Settings]
→ [Fax Settings] → [Send Setting] → [Recall in Case of Line Busy]
To cancel transmission, tap the job status display on the operation panel, tap
the key of the job you want to delete, and tap [Stop/Delete] on the action panel.
A message will appear to confirm the cancelation. Tap the [Cancel] key.
■ If an error occurs preventing transmission, the transmission is temporarily
canceled and then automatically re-attempted after a brief interval. The factory
default setting : Two attempts at 3-minute intervals.
"Settings (administrator)" → [System Settings] → [Image Send Settings] →
[Fax Settings] → [Send Setting] → [Recall in Case of Communication Error]
To cancel transmission, tap the job status display on the operation panel, tap
the key of the job you want to delete, and tap [Stop/Delete] on the action panel.
A message will appear to confirm the cancelation. Tap the [Cancel] key.
The machine supports error correction mode (ECM) and is configured to
automatically resend any part of a fax that is distorted due to noise on the line.
"Settings" → [System Settings] → [Image Send Settings] → [Fax Settings] →
[Condition Settings] → [ECM]
39
Page
45
45
46
46
46
46
47
47
47
47
Hide quick links:
Advertisement
