Planet WGS-4215-T User Manual page 30

■ Gigabit TP Interface
10/100/1000BASE-T copper, RJ45 twisted-pair: Up to 100 meters.
■ 100/1000BASE-X SFP Slots (WGS-4215-8T2S and WGS-4215-8P2S only)
Each of the SFP (Small Form-factor Pluggable) slots supports dual-speed, 1000BASE-SX/LX or 100BASE-FX
- For 1000BASE-SX/LX SFP transceiver module: From 550 meters (multi-mode fiber) to 10/30/50/70/120 kilometers
(single-mode fiber).
- For 100BASE-FX SFP transceiver module: From 2 kilometers (multi-mode fiber) to 20/40/60 kilometers (single-mode
fiber).
■ AC/DC Power Receptacle
The Managed Switch features a strong dual power input system (terminal block and DC jack) incorporated into customer's
automation network to enhance system reliability and uptime.
To install the 3-pin Terminal Block Connector on the Wall-mount Managed Switch, follow the following steps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into V-, and grounding wire into Ground.
Step 2: Tighten the wire-clamp screws for preventing the wires from loosening.
In some areas, installing a surge suppression device may also help to protect your Managed Switch
Power Notice:
from being damaged by unregulated surge or current to the Managed Switch.
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the Managed Switch without turning off and on the
power. The following is the summary table of reset button functions:
Power Input
Range
Model
WGS-804HPT
WGS-4215-8T
WGS-4215-8T2S
WGS-4215-8P2S
WGS-4215-16P2S
User's Manual of WGS Managed Series
3-pin Terminal Block
48~56V DC
12~48V DC,
24V AC
12~48V DC,
24V AC
48~56V DC
48~56V DC
30
DC Jack
48~56V DC
12~48V DC,
24V AC
12~48V DC
48~56V DC
48~56V DC