SWITCH BETWEEN MODES
Press SELECT. The select mode will flash. The display
will stop flashing if no key is pressed within 5 seconds.
CHANGE SETTINGS
Press and hold SELECT for 2 seconds. Then, press UP
or DOWN to change each setting. Press SELECT to
switch options.
REMOTE UNIT SET UP
Up to 3 remote units can be used with this product to
monitor outdoor temperature and humidity. The
measurement unit (°C or °F) and channel number (1, 2,
or 3) switches are located in the battery compartment,
and should be set prior to installation.
PS-L02_GB-final.p65
11
NOTE Additional remote units sold separately. If you
are using more than one remote unit, be sure to select a
different channel number for each unit.
INSTALLATION
Mount the remote unit on a flat surface using the recess
holes on the back of the unit.
For best results:
•
Before you insert the batteries, select the
measurement unit and channel number first.
•
Place the unit out of direct sunlight and moisture.
•
Do not place the remote unit more than 20 – 30
meters (60 – 90 feet) from the main (indoor) unit.
9
8/8/03, 12:17 PM