Panasonic WV-S2570L Important Information Manual page 16

■ Cables
A
RJ45 Network cable
Connect an Ethernet cable (category 5e or better
IMPORTANT:
⿟ Use all 4 pairs (8 pins) of the Ethernet cable.
⿟ The maximum cable length is 100 m {328 feet}.
⿟ Make sure that the PoE device in use is compliant with IEEE802.3af standard.
⿟ When connecting both the 12 V DC power supply and the PoE device for power supply,
12 V DC will be used for power supply.
⿟ When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
B Power supply terminal (12 V DC) / 2P power cable (accessory)
Caution:
⿟ A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE
EQUIPMENT POWERED BY 12 V DC POWER SUPPLY.
⿟ ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
Connect the output cable of the DC power supply to the 2P power cable (accessory).
A
RJ45 Network cable
E Alarm I/O cable
MONITOR OUT terminal
F
(factory shipment: NTSC monitor)
Ethernet cable (category 5e or better, straight)
E
4P alarm cable (accessory)
B
2P power cable (accessory)
 P ower supply
B
terminal (12 V DC)
C
Audio input cable (white)
D Audio output cable (black)
, straight
) to the network connector.
16
12 V DC (red)
GND (black)