Electrical Information - Napoleon B30NTR-1 Installation And Operation Manual

5.0 electrical information

electrical information
EN
WARNING
!
• Do not wire 110 volts to the valve or wall switch.
TRANSFORMER
BATTERY
HOUSING
DC SUPPLY
WHERE APPLICABLE, APPLIANCES WITH "B" VENT ADAPTORS MUST HAVE THE SPILL SWITCH WIRED IN
SERIES WITH EITHER THE EXISTING SWITCH OR OPTIONAL WALL SWITCH, THERMOSTAT OR REMOTE.
note:
This appliance comes equipped with a battery back-up. If this backup is used, install 4 'AA' batteries (not sup-
plied) into the holder and connect to the wire harness. Connect the battery holder to the wire harness before
using the appliance. Place near the IPI board. If the backup is used, it must be connect to this 6 volt battery
pack (supplied).
38
W415-1768 / C / 03.08.19
ACS/IPI
SWITCH*
(OPTIONAL)
ON / OFF
SWITCH
IPI / CPI*
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH. CONNECT
AN OPTIONAL THERMOSTAT
OR REMOTE CONTROL AND
(IF ALLOWED WITH THIS
APPLIANCE) A "B" VENT
ADAPTOR.
DFC Digital Fireplace Control
DC Direct Current
Intermittent Pilot Ignition
IPI
CPI Continuous Pilot Ignition
ACS Anti-Condensation Switch
*Some jurisdisctions may prohibit the use of a standing pilot. In
these jurisdictions, the anti-condensation switch shall be
disconnected to comply with local codes. To disconnect,
locate the white connector at the end of the white and blue
wires of the ACS switch and disconnect.
VALVE
GROUND
EYELET
GROUND
Legend
GREEN
ORANGE
ELECTRONIC
VALVE
IPI BOARD
DFC
-