Usb Sleep And Charge Function - Toshiba SATELLITE P300 User Manual

USB Sleep and Charge function

Problem
I cannot use the "USB
Sleep and Charge
function".
The battery depletes
quickly even when I
have turned OFF the
power of the computer.
User's Manual
Procedure
The setting of "USB Sleep and Charge function"
may be [Disabled]. Change the setting to
[Enabled] in the HW Setup.
When there is a current overflow of the external
device connected to the compatible port, USB
bus power (DC5V) supply may be stopped for
safety reasons. When the happens, disconnect
an external device if some external devices are
connected. After that, turn the power of the
computer ON/OFF to restore the function. If this
function can not be still used even if only one
external device is connected, stop using the
external device because its current is over the
acceptable value of this computer.
Some external devices may not be able to use
the "USB Sleep and Charge function.". In this
case, please try one or more of the following
methods.
■
Change a mode setting of [Enabled] by the
HW Setup.
■
Turn OFF the computer while external
devices are connected.
If this function can not be still used, change the
setting to [Disabled] in the BIOS Setup and stop
using the function.
When "USB Sleep and Charge function" is set to
[Enabled] in the HW Setup, USB bus power
(DC5V) will be supplied to the external device
connected to the compatible port. If external
device is connected to the compatible port when
the AC adaptor is not connected to the computer,
the battery of the computer will be depleted even
when the power of the computer is turned OFF.
Connect the AC adaptor to the computer or
change the "USB Sleep and Charge function"
setting the [Disabled] in the HW Setup.
Instead use a USB Port that does not have the
USB Sleep and Charge function-compatible icon
( ).
Troubleshooting
9-13